Start Searching the Answers
The Internet has many places to ask questions about anything imaginable and find past answers on almost everything.
If your ice maker isn’t producing ice at all or is producing crescents or cubes that are smaller than usual, it’s typically indicative of a clog somewhere along the supply line. Cause: A common cause for a clog is frozen water in the line. Fix: To repair a frozen line, slide the refrigerator and unplug it.
Press the on/off Switch If you can’t find the reset button nor the feeler arm, you can try pressing the on/off switch. This switch should also reset the ice maker and should get it working again properly. Underneath the ice tray and cover plate. (For some Whirlpool ice maker models you have to remove both)
If there are no bubbles, the filter may not be working. Therefore, repair or replace the filter. The most likely cause is that the air pipes of the filter are disconnected or blocked or the air pump has broken down (See Q1). If the filter and pump is working and the tank is still cloudy, then the water is contaminated.
The first, and most common reason is that your water tube in the door is frozen. Another possible cause for this issue is a faulty water inlet valve. This valve opens the water supply to the dispenser; therefore, if the valve is defective or if the water pressure is too low, the water valve won’t open.
For low pressure, irregular dispensing, and lack of water, consider the possibility of a clog. Clogs are especially likely if there is a flaw in the water line or if the water filter is not up to date. Inspect the water line in segments and the components that run water through them for the possibility of a clog.
If you’re not getting any water in your home, it’s likely because of a problem with the water main. If you have an emergency shut-off valve, it could have accidentally triggered and stopped your water flow, or the valve could be open and impeding your water supply because it’s leaking.
Make sure the control panel setting on the fridge is not set to ROOM TEMP WATER. Make sure the fridge is connected to a cold water supply and not hot water supply, the refrigerator should always be connected to a cold water supply. Give the refrigerator time to get back to temperature and chill the water.
This is very easy to do: First, remove a few cups of water from your machine, then completely unplug your water cooler from the mains. We then suggest leaving your machine for 24 hours before switching it on again. After 24 hours, plug it back in and wait 6 hours for the water to adjust to a cooler temperature.
They are always full with filtered water, so you don’t have to wait. Unlike all other home filters of tap water, refrigerator filters do their job while you aren’t using them and store the filtered water in a container. This way the water is always ready to drink and you don’t need to wait to get it filtered.